Dear Sirs,
Thank you very much for your good advice. I HAVE SOME PROBLEM WITH SPCOLUMN FOR anylyze hollow circular section with 2 openings.
When I try to create similar to below picture with 2 openings by section editor and when i try to save&exit to get back to main window, it shows that " multiple shapes will be combined into one". Then I click OK. but it show error that " section must contain only one solid" and cannot combine into one.
I did the following steps
Could you please advise do i miss something or any steps
Thank you very much for your good advice. I HAVE SOME PROBLEM WITH SPCOLUMN FOR anylyze hollow circular section with 2 openings.
When I try to create similar to below picture with 2 openings by section editor and when i try to save&exit to get back to main window, it shows that " multiple shapes will be combined into one". Then I click OK. but it show error that " section must contain only one solid" and cannot combine into one.
I did the following steps
- Make a hollow circular section
- Make two openings and then combine, then the drawing shows the separate sections as sample attach, but the problem is I cannot save and exit as above explain.
Could you please advise do i miss something or any steps